Electrician in
Pilot Point, TX
Pilot Point is two electrical towns at once. Around the square there are houses wired generations ago. North and east of it, whole subdivisions are going in on poles that were set in the last couple of years. The work is not the same in each.
CoServ Country, With Exceptions
Most of Pilot Point is cooperative territory rather than the deregulated setup people assume applies everywhere in Texas. That changes who has to attend when a job needs the power dropped, and it changes the lead time.
CoServ
An electric cooperative, not a retailer you pick off a comparison site. CoServ says on its own site that it brought power to this area decades ago and is building out the poles for Mobberly Farms, with Bryson Ranch and Eland Farms to follow. If you are in one of the new developments, this is almost certainly you.
Texas-New Mexico Power
TNMP is listed as the transmission and distribution utility for the 76258 ZIP on the retail-rate services, which is the deregulated arrangement where your retailer is a separate company from the wires company. Which one covers a given address here is not something to assume.
So the first question on anything touching the service is simply: what does your bill say? Inside the house it changes nothing. On a panel replacement, a new service, a meter move or anything needing a disconnect, it decides who we book and how far ahead.
Working In Pilot Point
A Town Growing Faster Than Its Older Grid
Pilot Point has old housing stock and brand-new housing stock and very little in between. On the older properties the questions are capacity, grounding and what has been added over the years. On the new ones it is getting the design right before the walls close.
Work that needs permitting is handled under our own licence and the paperwork comes to you. On a house that has been added to across several decades, that record is worth having.
- Local authority
- City of Pilot Point
- Electric utility
- CoServ or TNMP — check your bill
- County
- Denton County
- Licence on the job
- Master Electrician TDLR 705467 · TECL 39791
What We Are Called Out For In Pilot Point
Pilot Point splits neatly into two kinds of job: bringing an older house up to what a modern household actually draws, and wiring a new one properly from the temporary pole onward.
Electrical Panels
Older Pilot Point houses are frequently on a service sized for a very different household. We run the load calculation first and tell you whether it genuinely needs upgrading — up to 400A on a large property — rather than selling you a bigger box by default.
New Construction
Temporary power, grounding before the pour, full rough-in and trim-out. On the new developments going in around the town this is the whole job, start to finish, under one licence.
Fault Finding
Tripping breakers and dead circuits traced to a cause. On a house that has been extended and rewired in pieces over the years, that tracing is most of the work.
EV Chargers
Level 2 on a dedicated circuit. Out here the runs are often longer than people expect, and the cable size and the panel capacity both have to carry it.
Work We Can Show You
Service equipment and conduit outside
Exterior wall installation
Set out before the ceiling was closed up
Day-to-day work across Frisco and North Dallas–Fort Worth. Jobs photographed in Pilot Point will be added here as we build the record. See all projects
Pilot Point Questions
Am I on CoServ or TNMP?
Your bill settles it. CoServ is a cooperative and covers a lot of this area, including the new developments it has been building poles for. TNMP is listed as the wires company for the 76258 ZIP on the retail-rate services. We ask before quoting anything that touches the service, because it changes who has to attend.
Does it actually matter which one I am on?
For work inside the house, no. For a panel replacement, a new service, a meter move or anything needing the power dropped, very much. It decides who we book and how long the lead time is, and that goes into the schedule rather than being discovered on the day.
Is there anything I need to arrange?
Only one thing: if the power needs disconnecting for the work, the utility will only take that request from you as the account holder. Everything else is ours — where the City requires paperwork we handle it as part of the job, and you keep the record.
Can you wire a new build out here from scratch?
Yes. That is the temporary supply from the pole, the grounding electrode in the foundation before the concrete goes in, the full rough-in at frame stage and then panels, outlets, switches and lighting at trim-out. One contractor across the whole scope.
How far out is Pilot Point for you?
We are based in Frisco and work north through Celina, Aubrey and Oak Point, so Pilot Point is on a road we already travel. Call Alex on +1 503 380 0024 and he will tell you honestly when he can be there.
Service Area
We Also Serve
ADP Electrical works across Frisco and the surrounding towns of North Dallas–Fort Worth. Not sure whether we cover you? Call and ask — we usually do.
Covering all nineteen towns in our service area, and often a little beyond. Ask if you are not listed.
Free Estimate
Get a Price For Work in Pilot Point
Tell us what the property is and roughly when it was built — out here that answer usually tells us more about the job than the symptom does.
Serving Frisco, Prosper, Celina, McKinney, Plano and North Dallas–Fort Worth.